< Back ×
My Vehicle Change Vehicle
2005 Buick LeSabre
< Back to View All
Fuses & Fuse Box
- Department
- Prices
OEM (Genuine) 2005 Buick LeSabre Block Asm-Engine Wiring Harness Junction
PartNumber: 21994197
Product Specifications- Other Names: Fuse & Relay Box
- Item Dimensions: 11.9 x 9.6 x 5.5 inches
- Item Weight: 3.90 Pounds
- Fitment Type: Direct Replacement
- Part Description: 2005 Buick LeSabre Block Asm-Engine Wiring Harness Junction
Vehicle Fitment- 2005 Buick LeSabre | Custom, Limited | 6 Cyl 3.8 L GAS
OEM (Genuine) 2005 Buick LeSabre HOLDER, Main Wiring Junction and Fuse Block
PartNumber: 12193968
Product Specifications- Notes: Fuse
- Other Names: Fuse Holder, Holder
- Item Dimensions: 1.4 x 1.0 x 0.5 inches
- Item Weight: 0.30 Pounds
- Fitment Type: Direct Replacement
- Part Description: 2005 Buick LeSabre HOLDER, Main Wiring Junction and Fuse Block
Vehicle Fitment- 2005 Buick LeSabre | Custom, Limited | 6 Cyl 3.8 L GAS
FAQ for Fuse Box Repair
Q: How do I install the Rear Electrical Center or Junction Block?
A:
You should install all the connectors to the rear fuse block and hand start the fasteners, install the rear electrical center into the base assembly, install the positive battery cable and nut, install the rear seat cushion and connect the negative battery cable.
By Bob
GM Specialist
01/11/2022Q: What is the recommended torque when installing the positive battery cable fastener?
A:
The recommended torque is 15 N.m (11 lb-ft).
By Bob
GM Specialist
01/11/2022Q: What should be noticed in installing the Underhood Electrical Center or Junction Block?
A:
You should install the accumulator cover, install the wiring harness into the clip in the accumulator cover and position the positive cables onto the stud.
By Bob
GM Specialist
01/11/2022Q: What should be noticed when removing the Underhood Electrical Center or Junction Block?
A:
You should disconnect the positive battery cables fastener from the underhood fuse block., disconnect the wiring harness clip from the accumulator cover and position the cables out of the way, disconnect the retaining clip securing the evaporator hose to the accumulator cover and carefully position the evaporator hose out of the way.
By Bob
GM Specialist
01/11/2022Q: How do I remove the Rear Electrical Center or Junction Block?
A:
You should remove the rear seat cushion, disconnect the negative battery cable, remove the rear fuse block cover, remove the positive battery cable nut and cable from the rear electrical center, release the four retaining clips, lift the electrical center and turn over and remove the three connector fasteners and remove all the connectors from the fuse block.
By Bob
GM Specialist
01/11/2022