< Back ×
My Vehicle Change Vehicle
2005 Buick LeSabre
< Back to View All
Fuel Systems
- Department
- Brands
- Prices
Dorman® Inlet Fuel Line Connector for 2005 Buick LeSabre
PartNumber: 800-058Product Specifications- Notes: Inlet; Nylon Straight; 3/8 x 3/8; Pkg Quantity: 1; Packaging Type: Bag
- Fitting Attachment End 1: Quick Disconnect
- Fitting Attachment End 2: None
- Fitting Size End 1: 3/8''
- Fitting Size End 2: 3/8''
- Fuel Line Connector Design: Quick Disconnect
- Gasket Material: Rubber
- Material: Plastic
- Package Quantity: 1
- Packaging Type: Bag
- UPC: 019495025894
- Part Description: 2005 Buick LeSabre Inlet Fuel Line Connector
Vehicle Fitment- 2005 Buick LeSabre | All Trims | All Engines
$19.13
Dorman® Inlet Fuel Line Connector for 2005 Buick LeSabre
PartNumber: 800-059Product Specifications- Notes: Inlet; Nylon Elbow; 3/8 x 3/8; Pkg Quantity: 1; Packaging Type: Bag
- Fitting Attachment End 1: Quick Disconnect
- Fitting Attachment End 2: None
- Fitting Size End 1: 3/8''
- Fitting Size End 2: 3/8''
- Fuel Line Connector Design: Quick Disconnect
- Gasket Material: Rubber
- Material: Plastic
- Package Quantity: 1
- Packaging Type: Bag
- UPC: 019495025979
- Part Description: 2005 Buick LeSabre Inlet Fuel Line Connector
Vehicle Fitment- 2005 Buick LeSabre | All Trims | All Engines
$18.73
FAQ for Fuel Line Connector Repair
Q: How to install the Fuel Line Coupler?
A:
You should apply a few drops of clean engine oil to the male pipe end, push both sides of the fitting together to cause the retaining tabs to snap into place, and pull on both sides of the fitting to make sure the connection is secure. If applicable, you should install the quick-connect fitting retainer.
By Bob
GM Specialist
01/11/2022Q: How to remove the Fuel Line Coupler?
A:
You should relieve the fuel system pressure, remove the retainer from the quick connect fitting, then low dirt out of the fitting using compressed air, choose the correct tool from J 37088-A for the size of the fitting, insert the tool into the female connector, then push inward to release the locking tabs, pull the connection apart, wipe off the male pipe end, inspect both ends of the fitting for dirt and burr and clean or replace the components as required.
By Bob
GM Specialist
01/11/2022Q: How to remove the Quick Connect Fitting(S) (Plastic Collar)?
A:
You should relieve the fuel system pressure and remove the retainer from the quick-connect fitting if applicable, low any dirt out of the quick-connect fitting using compressed air, squeeze the plastic retainer release tabs, pull the connection apart, use a clean shop towel to wipe off the male fuel pipe end, inspect both ends of the quick-connect fitting for dirt and burrs and clean or replace components/assemblies as required.
By Bob
GM Specialist
01/11/2022Q: How to install the Quick Connect Fitting(S) (Plastic Collar)?
A:
You should apply a few drops of clean engine oil to the male fuel pipe end, push both sides of the quick-connect fitting together to cause the retaining tabs/fingers to snap into place, pull on both sides of the quick-connect fitting to make sure the connection is secure, once installed and install the retainer on to the quick-connect fitting.
By Bob
GM Specialist
01/11/2022