2005 Buick LeSabre | Custom, Limited | 6 Cyl 3.8 L GAS
FAQ for A/C Condenser Repair
Q: What tools are required to replace the Condenser HVAC?
A:
You need J 39400-A Halogen Leak Detector.
By Bob
GM Specialist
01/11/2022
Q: What is the recommended torque when installing the front fascia to tie bar support brackets and bolts?
A:
The recommended torque is 9 N.m (7 lb-ft).
By Bob
GM Specialist
01/11/2022
Q: What should be noticed in removing the Condenser HVAC?
A:
The bolt retaining the condenser to the radiator end tank is a special length and should be the ONLY bolt used upon reinstallation. The use of a longer bolt will damage the radiator end tank.
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: How to install the Air Temperature Sensor-Lower Right?
A:
You should connect the electrical connector to the Air Temperature Sensor, install the air temperature sensor into the sound insulator and turn 1/4 turn clockwise and install the right sound insulator.
Q: What should be noticed in removing the Heater Core?
A:
You should position the J 38185 to remove the heater hose clamps, remove the heater hoses from the Heater Core, remove the left side sound insulator and remove the right side sound insulator.
Q: How to remove the Heater Pipe Adapter-Inlet?
A:
You should drain the cooling system, remove the Heater Hose from the heater inlet pipe adapter using the J 38185, remove the bolt from the heater pipe adapter and remove the heater inlet pipe adapter from the engine.