FAQ for Pillar Panels Repair
Q: What tool can be used to remove the rear upper garnish molding?
A:
You can use the J 38778.
By BobGM Specialist
02/11/2022 Q: How do you replace the right rear quarter trim panel?
A:
You can remove the following: the rear seat, the garnish molding, the trim panel, the door sill plate, the quarter panel trim screws, and the quarter panel trim from the vehicle.
By BobGM Specialist
02/11/2022 Q: What is the removal procedure for the third pillar trim?
A:
The procedure is to remove the following: the rear door sill trim plate, the lower rear seat belt cover and bolt, and the trim panel from the vehicle.
By BobGM Specialist
02/11/2022 Q: How do you replace the third pillar trim (Tahoe/Yukon/Escalade/Suburban)?
A:
You can remove the following: the rear door sill trim plate, the lower rear seat belt cover and bolt, and the trim panel from the vehicle.
By BobGM Specialist
02/11/2022 Q: What tool can you use to remove the rear upper garnish molding?
A:
You can use the J 38778.
By BobGM Specialist
02/11/2022 Q: What is the installation procedure for the right rear quarter trim panel?
A:
The procedure is to install the following: the quarter panel trim, the quarter panel trim screws, the door sill plate, the trim panel, the garnish molding, and the rear seat.
By BobGM Specialist
02/11/2022 Q: What is the purpose of pulling down on the upper corners of the garnish molding?
A:
The purpose is to disengage the retaining clips.
By BobGM Specialist
02/11/2022 Q: What is the removal procedure for the left rear quarter trim panel (Suburban)?
A:
The procedure is to remove the following: the rear seat, the garnish molding, the trim panel, the door sill plate, the quarter panel trim screws and the quarter panel trim from the vehicle.
By BobGM Specialist
02/11/2022 Q: How do you install the rear upper garnish molding?
A:
You can install the roof rear upper garnish molding to the vehicle until it clicks into place.
By BobGM Specialist
02/11/2022 Q: What is the recommended torque when installing the screws retaining the seat back release handle and the seat recliner handle to the seat?
A:
You can tighten the screws to 2 N.m (18 lb in).
By BobGM Specialist
02/11/2022 See more FAQs (39)