Part Description: 2004 GMC Yukon Shaft Kit, Rear Wheel Drive
More Info
Vehicle Fitment
2004 GMC Yukon | Denali, SLE, SLT | 8 Cyl 4.8 L GAS, 8 Cyl 5.3 L FLEX, 8 Cyl 5.3 L GAS, 8 Cyl 6.0 L GAS
1-30 of 40 Results
< Previous
12
Next >
FAQ for Axle Shaft Repair
Q: What tool can be used to press the wheel drive shaft from the hub?
A:
You can use the J 45859 or equivalent.
By Bob
GM Specialist
01/11/2022
Q: What is the first step for replacing the rear axle shaft (8.6 Inch Axle W/OJL4, 9.5 Inch Axle)?
A:
The first step is to raise the vehicle.
By Bob
GM Specialist
01/11/2022
Q: What is the recommended torque when installing the axle flange bolts?
A:
You can tighten the rear axle flange bolts to 156 Nm (115 ft. lbs.).
By Bob
GM Specialist
01/11/2022
Q: What can you use to remove the axle shaft from the housing?
A:
You can use the J45859 and the J2619-01.
By Bob
GM Specialist
01/11/2022
Q: What is the removal procedure for the rear axle shaft and/or gasket?
A:
The procedure is to remove the following: the tire and wheel, the flange bolts, the axle shaft from the tube, and the gasket.
By Bob
GM Specialist
01/11/2022
Q: How do you install the rear axle shaft (9.75 Inch Axle)?
A:
You can install the following: the spring-loaded lock clip, the steering knuckle assembly, the rear steering gear assembly, and the tire and wheel assembly.
By Bob
GM Specialist
01/11/2022
Q: What is the purpose of wrapping shop towels around both the inner and the outer wheel drive shaft boots?
A:
The purpose is to avoid damage to the boots during removal and installation.
By Bob
GM Specialist
01/11/2022
Q: What is the recommended torque when installing the new pinion shaft locking bolt?
A:
You can tighten the pinion shaft locking bolt to 34 Nm (25 ft. lbs.).
By Bob
GM Specialist
01/11/2022
Q: What is the first step for replacing the rear axle shaft (9.75 Inch Axle)?
A:
The first step is to release the park brake.
By Bob
GM Specialist
01/11/2022
See more FAQs (4)
FAQ for Other Repair Info
Q: What is the removal procedure for the front drive axle lubricant?
A:
The procedure is to remove the following: the front Differential carrier shield, the fill plug, and the drain plug.
Q: How do you install the rear axle shaft seal?
A:
You can install the Axle Shaft Seal, install the axle shaft and install the tire and wheel assembly.
Q: What is the first step for replacing the external snap ring universal joint?
A:
The first step is to support the propeller shaft in a line horizontal with the table of a press.