< Back ×
My Vehicle Change Vehicle
2004 Chevrolet S10
< Back to View All
Air Filters & Intake Systems
- Department
- Prices
OEM (Genuine) 2004 Chevrolet S10 Throttle Body Assembly
PartNumber: 12595276
Product Specifications- Notes: 4.3l Sfi
- Other Names: Throttle Body
- Item Dimensions: 8.2 x 6.3 x 6.1 inches
- Item Weight: 2.20 Pounds
- Fitment Type: Direct Replacement
- Replaces: 88894295, 17113650
- Part Description: 2004 Chevrolet S10 Throttle Body Assembly
Vehicle Fitment- 2004 Chevrolet S10 | Base, LS, Xtreme, ZR2, ZR5 | 6 Cyl 4.3 L GAS
FAQ for Throttle Body Repair
Q: What should be learned about before removing the Throttle Body Assembly?
A:
An 8-digit part identification number is stamped on the bottom of the throttle body casting.
By Bob
GM Specialist
02/11/2022Q: What should be noticed while installing the Accelerator Controls Cable?
A:
The accelerator pedal should operate freely without binding between closed and wide open throttle.
By Bob
GM Specialist
02/11/2022Q: What should be noticed while installing the Throttle Body Assembly?
A:
You shall check for unrestricted and complete throttle opening and closing positions by operating the accelerator pedal, and check for poor carpet fit under the accelerator pedal. The throttle should operate freely without bind between fully closed and wide open throttle.
By Bob
GM Specialist
02/11/2022Q: What should be noticed while cleaning the Throttle Body?
A:
You must not subject such throttle body assembly to an immersion cleaner or a strong solvent as throttle position (TP) sensor, Idle air control (IAC) valve, and Sealed throttle shaft bearing.
By Bob
GM Specialist
02/11/2022Q: What is the removal procedure for the Accelerator Controls Cable?
A:
The procedure is to remove the air cleaner outlet duct, the accelerator cable both from the accelerator control cable bracket and from the cable routing bracket, the left closeout/insulator panel, and the accelerator cable.
By Bob
GM Specialist
02/11/2022Q: What should be noted when cleaning and inspecting the Idle Air Control (LAC) Valve?
A:
You must not reuse the original O-ring.
By Bob
GM Specialist
01/11/2022Q: What is the removal procedure for the Idle Air Control (LAC) Valve?
A:
The procedure is to remove the air cleaner outlet resonator, disconnect the idle air control (IAC) valve harness connector, and remove the IAC valve and O-ring.
By Bob
GM Specialist
01/11/2022See more FAQs (2)