Part Description: 2004 Cadillac SRX Ignition Knock Sensor
More Info
Vehicle Fitment
2004 Cadillac SRX | All Trims | 6 Cyl 3.6L
$14.12
FAQ for Knock Sensor Repair
Q: What is the removal procedure for the Bank 1 knock sensor (KS)?
A:
The procedure is to turn the ignition OFF, raise the vehicle, reposition the wiring harness heat shield, remove the knock sensor (KS) electrical connector, remove the KS bolt and remove the KS.
By Bob
GM Specialist
01/11/2022
Q: What is the recommended torque when you install the KS bolt?
A:
You can tighten the KS bolt to 23 N.m (17 lb-ft).
By Bob
GM Specialist
01/11/2022
Q: What is the first step for replacing the Bank 2 knock sensor (KS)?
A:
The first step is to turn the ignition OFF.
By Bob
GM Specialist
01/11/2022
Q: What is the recommended torque when installing the KS bolt?
A:
You can tighten the KS bolt to 23 N.m (17 lb-ft).
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: What is the removal procedure for the Bank 1 ignition coils?
A:
The procedure is to turn the ignition OFF and remove the following: the engine cover, the intake manifold, the Ignition Coil electrical connector(s), the ignition coil bolt(s), and the ignition coil(s).
Q: What is the recommended torque when installing the wire harness retainer and bolt to the side of the ECM bracket?
A:
You can tighten the wire harness retainer bolt to 23 N.m (17 lb-ft).