Part Description: 2004 Cadillac SRX Standard Direct Fit Catalytic Converter and Pipe Assembly
Vehicle Fitment
2004 Cadillac SRX | All Trims | 6 Cyl 3.6L
FAQ for Catalytic Converter Repair
Q: What is the first step for replacing the right catalytic converter (LY7)?
A:
The first step is to remove the right bank exhaust manifold heat shield.
By Bob
GM Specialist
01/11/2022
Q: What is the recommended torque when tightening the catalytic converter nuts?
A:
You can tighten it to 50 Nm (37 ft. lbs.).
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: What is the removal procedure for the engine oil and oil filter?
A:
The procedure is to turn the ignition OFF, remove the Oil Filter cap, remove the oil filter cartridge, raise the vehicle, place a suitable drain below the oil pan drain plug, remove the oil pan drain plug and allow the oil to drain completely.
Q: How do you install the oil filter adapter?
A:
You can install the following: the Oil Filter Adapter, the A/C compressor, the A/C compressor, and power steering drive belt, and the oil filter.
Q: What is the removal procedure for the heated oxygen sensor (Bank 1 Sensor 1)?
A:
The procedure is to turn the ignition OFF, disconnect the heated Oxygen Sensor (HO2S) electrical connector, remove the HO2S electrical connector, raise the vehicle and remove the HO2S from the catalytic converter.