Q: What should be noticed when servicing the Stop Lamp Switch?
A:
The stop lamp switch is self-adjusting when installed properly in the fully locked position. The twist lock type switch requires no further adjustment.
By Bob
GM Specialist
29/10/2022
Q: What should be noticed when adjusting the Stop Lamp Switch?
A:
The stop lamp switches are self-adjusting when they are installed properly in the fully locked position. The twist lock type switches do not need any further adjustment.
By Bob
GM Specialist
29/10/2022
Q: What is the removal procedure for the Stop Lamp Switch?
A:
Remove the left sound insulator. Disconnect the electrical connectors from the switch. Rotate the stop lamp/ABS/shift lock switch counterclockwise, then pull to remove the switch.
By Bob
GM Specialist
29/10/2022
FAQ for Other Repair Info
Q: What is the installation procedure for the Hazard And Turn Signal Flasher?
A:
Press the hazard switch into the bezel until the locking tabs lock. Connect the hazard switch electrical connector. Install the instrument panel right accessory trim plate.
Q: What is the removal procedure for the Hazard Warning Switch?
A:
Remove the instrument panel's right accessory trim plate. Disconnect the electrical connector. Remove the hazard switch by releasing the locking tabs. Remove the hazard switch.