Contact Us Live Chat or 1-888-220-8330
Search Bar
Search by Part Number or Keywords
  • My Garage
  • My Account
  • Cart
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting
Help Center
< Back ×
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting
Login/Register My Account Track Order Help Center Contact Us
Replacement and OEM Parts for 2004 Cadillac Escalade EXT Sway Bar Bushing

2004 Cadillac Escalade EXT Sway Bar Bushing

My Vehicle Change Vehicle
2004 Cadillac Escalade EXT
Change Vehicle
Vehicle Options
We need more information about your vehicle to make a correct determination of fitment
< Back to View All
Suspension System Components
  • Department
  • Series
  • Brands
  • Prices

12 Products found

3 Q&A for Sway Bar Bushing Repair
Show Item:
  • 30
  • 60
  • 90
Sort by:
Recommended
Filter
Sort
View by

FAQ for Sway Bar Bushing Repair

Q: What is the recommended torque for the oil pan skid plate retaining bolts?
A:
The recommended torque is 20 Nm (15 ft. lbs.).
By Bob
GM Specialist
02/11/2022
Q: What should be noticed when installing a stabilizer shaft insulator?
A:
You should place the stabilizer shaft insulators on the stabilizer bar with the slits facing toward the front of the vehicle.
By Bob
GM Specialist
02/11/2022
Q: What is the removal procedure for the stabilizer shaft insulator?
A:
You need to raise and support the vehicle, remove the tire and wheel assembly, the oil pan skid plate, the stabilizer shaft insulator bracket bolts, and the stabilizer shaft bracket, lower the stabilizer bar to remove the stabilizer shaft insulators and inspect all of the parts for wear and damage.
By Bob
GM Specialist
02/11/2022

FAQ for Other Repair Info

Q: What is the removal procedure for the steering knuckle (coil spring suspension)?
A:
You need to raise and support the vehicle, remove the tire and wheel, support the lower control arm, remove the wheel hub and bearing, disconnect the Electronic Suspension Control (ESC) link rod from the sensor, disconnect the outer tie rod from the knuckle, remove the brake hose bracket retaining bolt from the knuckle, the retaining nut and separate the upper and the lower ball joint, and the Steering Knuckle.
Q: What should be noticed when installing the rear brake hose?
A:
You should make sure the Brake Hose must not twisted and that the brake hose is not in contact with any suspension component.
Q: What should be noticed when adding fluid to the brake master cylinder reservoir?
A:
When adding fluid to the Brake Master Cylinder reservoir, you should use only Delco Supreme 11, GM P/N 12377967 (Canadian P/N 992667), or equivalent DOT-3 brake fluid from a clean, sealed brake fluid container.