Notes: Mode Door Actuator Connector; w/Manual AC Control; Auxiliary;w/ Dual Zone Climate Control; Right Main;w/Dual Zone Climate Control; Left Main;Recirculation Door Actuator Connector;w/Manual AC Control; Auxiliary;Mode Door Actuator Connector; w/ATC; Auxiliary;Mode Door Actuator Connector; w/o Rear Passenger A/C Conrols in Center Console; Main;w/ATC; Auxiliary;Mode Door Actuator Connector; w/Rear Passenger AC Conrols in Center Console; Main
Connector Shape: Rectangle
Gender: Male
Style: Harness Connector
Terminal Gender: Female
Terminal Pin Qty.: 6
Terminal Quantity: 6
Terminal Type: Pin
UPC: 096361007949
Wiring Harness Length: 12.000
Part Description: Hvac Heater Blend Door Actuator Connector
Q: What to do when technicians are to inspect the HVAC actuator harness?
A:
Technicians are to inspect the HVAC actuator harness for contact with the instrument panel support brace. Repair any damage to the actuator harness wiring and install a protective plastic conduit over the harness. Install friction tape over the sharp edge of the instrument panel brace. Clear the diagnostic trouble codes and verify proper HVAC system operation.
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: What is the installation procedure for the upper left air temperature sensor?
A:
You need to install the upper left Air Temperature Sensor to the air distributor duct and connect the electrical connector to the upper left air temperature sensor.
Q: What is the removal procedure for the auxiliary blower motor resistor?
A:
You need to remove the right rear quarter trim panel, disconnect the electrical connector from the Blower Motor Resistor, and remove the retaining screws from the blower motor resistor and the blower motor resistor from the vehicle.
Q: What is the removal procedure for the heater core (Visteon)?
A:
You need to Remove the HVAC module assembly, the screws from the Heater Core cover, the heater core cover, the heater core cowl gasket, and the heater core.