Other Names: Fuel Gauge Sending Unit, Level Sensor
Item Dimensions: 7.5 x 5.7 x 5.8 inches
Item Weight: 0.60 Pounds
Fitment Type: Direct Replacement
Part Description: Fuel Tank Meter/Pump SENSOR KIT
More Info
FAQ for Fuel Level Sensor Repair
Q: What is the installation procedure for the fuel level sensor (front tank)?
A:
You need to install the fuel level sensor, connect the level sensor electrical connector, and install the sending unit.
By Bob
GM Specialist
01/11/2022
Q: What is the installation procedure for the fuel level sensor (rear tank)?
A:
You need to install the fuel level sensor, connect the level sensor electrical connector, and install the sending unit.
By Bob
GM Specialist
01/11/2022
Q: What is the removal procedure for the fuel level sensor (rear tank)?
A:
You need to remove the sending unit, disconnect the level sensor electrical connector, release the level sensor retaining clip, squeeze the locking tangs together, and remove the fuel level sensor.
By Bob
GM Specialist
01/11/2022
Q: What is the removal procedure for the fuel level sensor (front tank)?
A:
You need to remove the sending unit, disconnect the level sensor electrical connector, release the level sensor retaining clip, squeeze the locking tangs together, and remove the fuel level sensor.
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: What does the threaded design be used to?
A:
Athreaded design is used with the E-85 5.3L (VIN Z-RPO L59) engine. A 1/4 turn design is used with all other gas engines. The 1/4 turn design has a shorter tether strap and will not allow the customer to drape the Fuel Cap over the hook on the filler door.
Q: What is the removal procedure for the fuel injector?
A:
You need to remove the fuel rail, remove and discard the Fuel Injector retainer clip, remove the fuel injector, and remove and discard the fuel injector retainer clip and the fuel injector O-ring seals.
Q: What is the cleaning procedure for the fuel system?
A:
You need to remove the sending unit, inspect the fuel strainer and the fuel pump inlet for dirt and debris, flush the Fuel Tank with hot water, pour the water out of the sending unit opening, and install the sending unit.