You need to remove the grille and the ambient air temperature sensor from their location, drill a hole into the front-end radiator support brace, remove the wire harness from the electrical connector, cut the terminals off and splice 206 mm (8 in) of wire to the harness. You also need to install the connector with new terminal and seals, a piece of conduit on the new harness, the connector to the sensor, the sensor from the back side of the brace, and conduit on the added wire harness, and use two tie straps to fasten the harness to the side of the front-end radiator support brace, and install the grille.
By BobGM Specialist
01/11/2022