< Back ×
My Vehicle Change Vehicle
2004 Cadillac CTS
< Back to View All
Light Relays, Switches & Control Modules
- Department
- Prices
OEM (Genuine) 2004 Cadillac CTS Flasher Asm-Hazard Lamp & Turn Signal Lamp
PartNumber: 25721769
Product Specifications- Notes: Cts; 10 Pin
- Other Names: Flasher
- Item Dimensions: 3.7 x 3.0 x 1.6 inches
- Item Weight: 0.60 Pounds
- Fitment Type: Direct Replacement
- Part Description: 2004 Cadillac CTS Flasher Asm-Hazard Lamp & Turn Signal Lamp
Vehicle Fitment- 2004 Cadillac CTS | Base, Luxury, Luxury Sport, V | 6 Cyl 2.8 L GAS, 6 Cyl 3.2 L GAS, 6 Cyl 3.6 L GAS, 8 Cyl 5.7 L GAS, 8 Cyl 6.0 L GAS
OEM (Genuine) 2004 Cadillac CTS Flasher Asm-Hazard Lamp & Turn Signal Lamp
PartNumber: 25716295
Product Specifications- Other Names: Flasher, Flasher Relay
- Item Dimensions: 3.2 x 2.1 x 2.1 inches
- Item Weight: 0.50 Pounds
- Fitment Type: Direct Replacement
- Part Description: 2004 Cadillac CTS Flasher Asm-Hazard Lamp & Turn Signal Lamp
Vehicle Fitment- 2004 Cadillac CTS | Base, Luxury, Luxury Sport, V | 6 Cyl 2.8 L GAS, 6 Cyl 3.2 L GAS, 6 Cyl 3.6 L GAS, 8 Cyl 5.7 L GAS, 8 Cyl 6.0 L GAS
FAQ for Flasher Units Repair
Q: How to remove the hazard and turn signal flasher?
A:
You should remove the driver-side I/P closeout/Insulator panel, remove the flasher module (2) off the I/P carrier, and then disconnect the electrical connector.
By Bob
GM Specialist
01/11/2022Q: How to install the hazard and turn signal flasher?
A:
You should connect the electrical connector to the flasher module, slide the flasher module retaining clip onto the I/P carrier, and then install the driver-side I/P closeout/Insulator panel.
By Bob
GM Specialist
01/11/2022Q: What is the removal procedure for the hazard and turn signal flasher?
A:
The procedure is to remove the driver-side I/P closeout/Insulator panel, remove the flasher module off the I/P carrier, and then disconnect the electrical connector.
By Bob
GM Specialist
01/11/2022Q: What is the proper way to install the hazard and turn signal flasher?
A:
The proper way is to connect the electrical connector to the flasher module, slide the flasher module retaining clip onto the I/P carrier, and then install the driver-side I/P closeout/Insulator panel.
By Bob
GM Specialist
01/11/2022