2004 Buick Rendezvous Windshield Washer Hose

You need to open the hood, disconnect the washer hose from the wiper arms and the air inlet grille panel, next remove the washer hose grommet from the grille panel, then disconnect the washer hose from the washer solvent container neck and the washer pump, and remove the washer hose from the vehicle.

You should position the washer hose to the vehicle, next install the washer hose to the washer pump, connect the washer hose to the washer solvent container neck, then install the washer hose grommet to the slot in the grille panel, and connect the washer hose to the air inlet grille panel and the wiper arms, finally close the hood.

You need to remove the right closeout/insulator panel, and the right cowl trim panel, then remove the right lower center pillar molding and the right rear lower quarter trim panel, disconnect the rear washer hose from the rear washer pump, remove the rear washer hose end out through the opening under the right side of the instrument panel, remove the tape that secures the rear washer hose to the right sill area, and remove the tape that secures the rear washer hose to the right rear quarter panel area, remove the rear washer nozzle, then pull the rear washer hose end out through the liftgate rubber conduit, pull the rear edge of the headliner down to gain access to the rear washer hose, remove the rear washer hose from inside of the rear roof panel, finally remove the rear washer hose.