FAQ for Interior Door Handle Repair
Q: How to remove the assist handle and rear coat hook (Rendezvous)?
A:
You need to rotate the assist handle downward, remove the screws from the handle assembly, remove the bulb socket assembly from the lamp assembly, disconnect the electrical connectors, and remove the assist handle assembly.
By BobGM Specialist
01/11/2022 Q: What is the proper way to install the assist handle and rear coat hook (Rendezvous)?
A:
You should connect the electrical connectors, install the bulb socket in the lamp assembly, position the pull handle, then install the screws to the assist handle and coat hook.
By BobGM Specialist
01/11/2022 Q: What is the installation procedure for the door handle?
A:
You should install the lock rod and the door handle rod to the rear inside door handle, install the rear inside door handle by inserting the tabs into the rear door inner panel slots, install the rivet to the rear inside door handle, install the rear door water deflector and install the rear door trim panel.
By BobGM Specialist
01/11/2022 Q: What is the proper way to install the front inside door handle?
A:
The proper way is to install the front inside door handle, install the lock rod and the door handle rod to the front inside door handle, install the rivet to the front inside door handle, install the water deflector to the front inside door handle and install the front door trim panel.
By BobGM Specialist
01/11/2022 Q: How do you remove the door handle?
A:
You can Remove the rear door trim panel, Remove the rear door water deflector, Remove the center of the rivets using a center punch, Drill out the rivet from the rear inside door handle, Remove the rear inside door handle from the rear door inner panel and Remove the lock rod and door handle rod from the rear inside door handle.
By BobGM Specialist
01/11/2022 Q: What is the proper way to install the assist handle (Rendezvous)?
A:
You should position the assist handle in the vehicle, then install the assist handle screws.
By BobGM Specialist
01/11/2022 Q: What is the proper way to install the Instrument Panel (I/P) Assist Handle?
A:
You should install the assist handle to the instrument panel, install the assist handle nuts, and install the I/P cluster trim plate bezel.
By BobGM Specialist
01/11/2022 Q: What is the recommended torque for the screws attaching to the assist handle and coat hook?
A:
The recommended torque is 3 N.m (27 lb in).
By BobGM Specialist
01/11/2022 Q: How to remove the assist handle (Rendezvous)?
A:
You need to pull down on the assist handle to expose the retaining screws, remove the assist handle screws, then remove the assist handle.
By BobGM Specialist
01/11/2022 Q: How to remove the assist handle and rear coat hook (Aztek)?
A:
You need to rotate the assist handle downward, remove the fasteners from the handle assembly, remove the bulb socket assembly from the lamp assembly, disconnect the electrical connectors, then remove the assist handle assembly.
By BobGM Specialist
01/11/2022 See more FAQs (10)