Part Description: 2004 Buick Rendezvous Block Asm-Accessory Wiring Junction
More Info
Vehicle Fitment
2004 Buick Rendezvous | CX, CXL, CXL Plus, Ultra | 6 Cyl 3.5 L GAS, 6 Cyl 3.6 L GAS
FAQ for Fuse Box Repair
Q: What is the proper way to install the console electrical center or junction block?
A:
You should install the BCM, install the console accessory wiring junction block into the bracket, secure the junction block retainers, next connect the electrical connectors to the junction block, install the electrical connectors bolts to the junction block, connect the BCM electrical connectors, install the front floor console, and connect the negative battery cable.
By Bob
GM Specialist
01/11/2022
Q: How to remove the console electrical center or junction block?
A:
You need to disconnect the negative battery cable, remove the front floor console, disconnect the electrical connectors from the body control module (BCM), disconnect the electrical connectors from the console accessory wiring junction block, release the retainers from the junction block, remove the junction block out of the bracket, then remove the BCM.
By Bob
GM Specialist
01/11/2022
Q: What is the recommended torque for the positive battery cable nut?
A:
The recommended torque is 16 Nm (12 lb-ft).
By Bob
GM Specialist
01/11/2022
Q: What is the recommended torque for the electrical connector bolts?
A:
The recommended torque is 6 N.m (54 lb in).
By Bob
GM Specialist
01/11/2022
Q: What is the proper way to install the underhood electrical center or junction block?
A:
The proper way is to align the electrical connectors to the slots in the underhood accessory wiring junction block bracket, install the underhood accessory wiring junction block, connect the positive battery cable, install the positive battery cable nut, install the underhood accessory wiring junction block cover and secure the retaining tabs and connect the negative battery cable.
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: What is the proper way to install the starter motor?
A:
The proper way is to install the Starter motor, install the starter motor bolts, install the torque converter cover, install the starter motor S terminal electrical lead and nut, install the starter motor BAT terminal electrical leads and nut, install the radiator air baffle assembly, lower the vehicle and install the battery ground (negative) cable to the battery.
Q: What should be noticed when servicing the battery-positive cable?
A:
When replacing Battery Cables, be sure to use replacement cables that are the same type, gauge, and length.
Q: How to remove the cruise control module?
A:
You need to remove the cruise control cable from the module and disconnect the electrical connector from the Cruise Control Module, then remove the cruise control module from the bracket.