2004 Buick Rendezvous | CX, CX Plus, CXL, CXL Plus, Ultra | 6 Cyl 3.4 L GAS, 6 Cyl 3.5 L GAS, 6 Cyl 3.6 L GAS
$9.55MSRP: $20.04
You Save: $10.49 (53%)
FAQ for Flasher Units Repair
Q: How do you install the hazard and turn signal flasher?
A:
You can install the hazard and turn signal flasher into the fuse panel and install the fuse panel cover.
By Bob
GM Specialist
01/11/2022
Q: What is the installation procedure for the hazard and turn signal flasher?
A:
You should install the hazard and turn signal flasher into the fuse panel and install the fuse panel cover.
By Bob
GM Specialist
01/11/2022
Q: How do you remove the hazard and turn the signal flasher?
A:
You can remove the fuse panel cover from the right side floor console and remove the hazard and turn signal flasher from the fuse panel.
By Bob
GM Specialist
01/11/2022
Q: What is the removal procedure for the hazard and turn signal flasher?
A:
You should remove the fuse panel cover from the right side floor console, then remove the hazard and turn signal flasher from the fuse panel.
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: What should you do to avoid future misdiagnosis after programming?
A:
You should turn the ignition off for 10 seconds, connect the scan tool to the data link connector, turn the ignition on with the engine off, use the scan tool to retrieve history DTCs from all modules, and clear all history DTCs.
Q: How do you remove the stop lamp switch?
A:
You can remove the left-side instrument panel insulator, disconnect the electrical connectors and remove the stop lamp switch from the brake pedal bracket.