2004 Buick Rendezvous Door Moldings

You need to open the rear door, pull the upper edge of the rear door body side molding out, to release the retainers, then use a thin, plastic flat-bladed tool may be used between the door and the molding to help release the retainers, drill a small hole into the center of the center retainer pins of the lower support retainer, install a small screw into the hole in the center retainer pin, remove the center retainer pin using small pliers and pulling out the center retainer pin, then remove the rear door body side molding lower support from the door.

You should position the lower support retainer with the notch down and the retainers to the holes in the door panel, install the center pins of the retainers, position the lower edge of the molding to the lower door retainer, align the door molding retainers to the holes in the door, press the molding to the door, then close the rear door.

You need to open the endgate, remove the push-in retainers from the inside rear edge of the rear quarter panel molding, use a heat gun J 25070, then use a plastic, flat-bladed tool to remove the upper edge of the rear quarter panel molding from the surface, pull the upper edge of the rear quarter panel molding out, to release the retainers, remove the rear quarter panel molding from the door, and remove the push-in retainer nuts from the D-pillar, if required, remove all adhesive from the rear door body panel, then clean the rear door panel surface.

The tools required include J 25070 Heat Gun.