< Back ×
My Vehicle Change Vehicle
2004 Buick Rendezvous
< Back to View All
Transmissions Components & Shifters
- Department
- Prices
OEM (Genuine) 2004 Buick Rendezvous Lever Asm, Shift
PartNumber: 88952013
Product Specifications- Other Names: Gear Shift Assembly, Shift Lever
- Item Dimensions: 8.4 x 4.3 x 4.5 inches
- Item Weight: 1.20 Pounds
- Fitment Type: Direct Replacement
- Part Description: 2004 Buick Rendezvous Lever Asm, Shift
Vehicle Fitment- 2004 Buick Rendezvous | CX, CX Plus, CXL, CXL Plus, Ultra | 6 Cyl 3.4 L GAS, 6 Cyl 3.5 L GAS, 6 Cyl 3.6 L GAS
FAQ for Automatic Transmission Shift Levers Repair
Q: What is the recommended torque for the automatic transaxle range selector lever retaining nut?
A:
The recommended torque is 20 Nm (15 ft. lbs.).
By Bob
GM Specialist
01/11/2022Q: What is the recommended torque for the shift lever retaining screw?
A:
The recommended torque is 7 Nm (62-inch lbs.).
By Bob
GM Specialist
01/11/2022Q: What is the proper way to install the Automatic Transmission Range Selector Cable Lever?
A:
You should install the automatic transaxle range selector lever to the automatic transaxle, install the automatic transaxle range selector lever retaining nut, install the automatic transaxle range selector lever cable to the automatic transaxle range selector lever, adjust the automatic transaxle range selector lever cable, then install the throttle body air inlet duct.
By Bob
GM Specialist
01/11/2022Q: What is the proper way to install the shift lever?
A:
The proper way is to insert the shift lever into the shift lever housing, install the shift lever retaining screw, and position the shift lever boot.
By Bob
GM Specialist
01/11/2022Q: How to remove the Automatic Transmission Range Selector Cable Lever?
A:
You need to remove the throttle body air inlet duct, remove the automatic transaxle range selector lever cable from the automatic transaxle range selector lever, remove the automatic transaxle range selector lever retaining nut, and remove the automatic transaxle range selector lever from the automatic transaxle.
By Bob
GM Specialist
01/11/2022Q: What is the recommended torque for the shift control nuts?
A:
The recommended torque is 10 Nm (89-inch lbs.).
By Bob
GM Specialist
01/11/2022Q: How to install the floor shift control?
A:
You need to install the shift control, tighten the shift control nuts, then install the shift cable to the shift control, install the shift control wire harness to the shift control, and adjust the shift control cable as necessary, finally install the console trim plate.
By Bob
GM Specialist
01/11/2022See more FAQs (2)