Part Description: 2003 GMC Sierra 3500 OE Solutions Outlet Oil Cooler Line
More Info
Vehicle Fitment
2003 GMC Sierra 3500 | All Trims | 8 Cyl 8.1L
$34.78
FAQ for Oil Cooler Line Repair
Q: How to install the engine oil cooler pipe?
A:
You can install a new retaining ring into each quick connector fitting, hook one of the open ends of the retaining ring in one of the slots in the quick connector, rotate the retaining ring around the connector, snap the plastic cap onto the quick connect fitting, and inspect and fill the engine oil to the proper level.
By Bob
GM Specialist
01/11/2022
Q: What is the recommended bolt torque for the inner axle housing bolts?
A:
The recommended bolt torque is 100 Nm (75 lb-ft).
By Bob
GM Specialist
01/11/2022
Q: How to install the oil line?
A:
You can install the oil cooler hose bracket bolt, the oil cooler hose adapter bolts, the differential carrier lower mounting bolt and nut, the differential carrier upper mounting bolt and nut, and the inner axle housing washers, and connect the engine oil cooler quick connect fittings.
By Bob
GM Specialist
01/11/2022
Q: How to remove the oil line?
A:
You can disconnect the engine oil cooler quick connect fittings, remove the oil cooler hoses from the clip, place jack or utility stands, remove the front differential carrier shield, and the differential carrier upper mounting bolt and nut.
By Bob
GM Specialist
01/11/2022
Q: How to remove the engine oil cooler pipe?
A:
You can disengage the plastic caps from the quick connect fittings, rotate the retaining ring around the quick connector, remove the engine oil cooler line, clean all of the components in a suitable solvent, dry them with compressed air, and inspect the fittings, the connectors, the cooler lines, and the cooler for damage, distortion, or restriction.
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: What is the removal procedure for the radiator support?
A:
The procedure is to remove the upper Radiator baffle, the headlamps, the upper condenser mounting bolts, the bolts, the front end diagonal brace, the fan shroud, the tie bar to radiator brace bolts, the radiator mounting bolts, the tie bar bolts, the upper headlamp housing support screws, and the tie bar.
Q: How to remove the water pimp?
A:
You can drain the cooling system, loosen the air cleaner outlet duct clamps, remove the radiator inlet hose clip from the outlet duct, the air cleaner outlet duct, the engine sight shield, the radiator vent inlet hose from the radiator hose clips, the fan blade, the surge tank outlet hose, the Water Pump, and gaskets.
Q: How to install the thermostat housing?
A:
You can install the thermostat and Thermostat Housing to the water pump, the thermostat housing bolts, and the radiator outlet hose.