< Back ×
My Vehicle Change Vehicle
2002 Buick Rendezvous
< Back to View All
Door Handles, Locks & Related Parts
- Department
- Prices
OEM (Genuine) 2002 Buick Rendezvous Gate Asm, Lift *Prime*
PartNumber: 88948286
Product Specifications- Item Dimensions: 62.3 x 14.3 x 56.7 inches
- Item Weight: 59.70 Pounds
- Replaced by: 88956117
- Part Description: 2002 Buick Rendezvous Gate Asm, Lift *Prime*
Vehicle Fitment- 2002 Buick Rendezvous | CX, CX Plus, CXL, CXL Plus | 6 Cyl 3.4 L GAS
FAQ for Liftgates Repair
Q: What should be done if the liftgate window is to be reused?
A:
You will need to tape off the inside of the window defogger grid and the electrical connectors.
By Bob
GM Specialist
01/11/2022Q: What should be noticed when removing the liftgate trim?
A:
You should take care not to damage the reveal molding when cutting out the liftgate window, and the reveal molding is not serviced separately.
By Bob
GM Specialist
01/11/2022Q: What should be done before cutting out a stationary window?
A:
You will need to apply a double layer of masking tape around the perimeter of the painted surfaces and the interior trim.
By Bob
GM Specialist
01/11/2022Q: What should be noticed when taping off and protecting the inner edges of the rear window defogger grid lines from the window removal tool?
A:
You will need to keep the cutting edge of the tool against the window and inspect the depth of the cutting blade before starting.
By Bob
GM Specialist
01/11/2022Q: What's the removal procedure for the end gate trim panel?
A:
The removal procedure is to open the end gate, remove the end gate inside handle from the end gate, and remove the end gate trim panel from the end gate inner panel using J 38778.
By Bob
GM Specialist
01/11/2022Q: Can I install the old fasteners to the trim panel?
A:
No, you cannot. You must discard the old trim panel fasteners and install new ones.
By Bob
GM Specialist
01/11/2022Q: What's the installation procedure for the end gate trim panel?
A:
The installation procedure is to install the new trim panel retainers to the end gate trim panel, align the end gate trim panel to the end gate inner panel, and install the end gate trim panel by firmly pressing in the area of the retainer clips until the clips are fully seated around the perimeter of the end gate trim panel, install the end gate inside handle to the end gate, and close the end gate.
By Bob
GM Specialist
01/11/2022Q: What's the installation procedure for the end gate water deflector?
A:
The installation procedure is to align the end gate door water deflector to the end gate inner panel, secure the water deflector at the corners, install the end gate water deflector, start pressing the adhesive pattern at the bottom center and work outward and upward to prevent puckering, then install the end gate trim panel.
By Bob
GM Specialist
01/11/2022Q: What must be done before installing the end gate trim panel?
A:
Before installing the end gate trim panel to the end gate inner panel, the old trim panel retainers must be discarded and replaced with new trim panel retainers.
By Bob
GM Specialist
01/11/2022Q: What's the recommended torque for the screws installed to the bottom of the trim panel?
A:
The recommended torque is 2 N.m (18 lb in).
By Bob
GM Specialist
01/11/2022See more FAQs (8)