FAQ for Pillar Panels Repair
Q: What is the proper way to install the garnish molding center pillar?
A:
You should position the pillar trim panel, and push in on the pillar trim panel to secure the pillar trim panel,.
By BobGM Specialist
02/11/2022 Q: How to remove the trim panel-rear window shelf?
A:
You need to remove the seat cushion, the seatback, and the sail panels, release the 3 push-in retainers if equipped, disconnect the electrical connectors, disengage the fabric fastener strips, and remove the rear shelf trim panel.
By BobGM Specialist
02/11/2022 Q: What is the proper way to install the trim panel-rear window shelf?
A:
You should install the rear shelf trim panel to the rear window, connect the electrical connectors, fasten the 3 push-in retainers, then press to secure the fabric fastener strips if equipped, and install the sail panels, and the seatback.
By BobGM Specialist
02/11/2022 Q: What kind of special tools will be required in the replacement of the garnish molding-front door frame?
A:
J38778 Door Trim Pad and Garnish Clip Remover.
By BobGM Specialist
02/11/2022 Q: How to remove the sail panel?
A:
You need to remove the sail panel from the rear shelf panel, remove the seat back, remove the seat belt to the floor pan retaining bolt, disengage the molding from the sail panel, then remove the seat belt.
By BobGM Specialist
02/11/2022 Q: What is the recommended torque when installing the seat belt to the floor pan retaining bolt?
A:
The recommended torque is 41 N.m (30 lb-ft).
By BobGM Specialist
02/11/2022 Q: How to remove the Garnish Molding-Center Pillar?
A:
You need to pull outward the center trim panel to disengage the clips.
By BobGM Specialist
02/11/2022 Q: How to remove the garnish molding-front door frame?
A:
You need to position the garnish molding on the door frame, install the push-in retainer to locate the molding, press the molding into place from the front to the rear, and install the door trim panel.
By BobGM Specialist
02/11/2022 Q: What is the installation procedure for the handle bezel- inside?
A:
The procedure is to connect the electrical connectors to the inside door handle bezel, pull the door handle about halfway open, slide the inside door handle through the opening in the door handle bezel, insert the tabs at the rear of the bezel behind the door trim panel, then snap the front of the door handle bezel into place.
By BobGM Specialist
01/11/2022 Q: What kind of special tools will be required when serving the water deflector-front door?
A:
J38778 Door Trim Pad and Garnish Clip Remover.
By BobGM Specialist
01/11/2022 See more FAQs (13)