< Back ×
My Vehicle Change Vehicle
2002 Buick LeSabre
< Back to View All
Air Filters & Intake Systems
- Department
- Prices
OEM (Genuine) 2002 Buick LeSabre Throttle Body Assembly
PartNumber: 24507226
Product Specifications- Notes: Bonneville, Lesabre; W/O Supercharger
- Other Names: Throttle Body
- Item Dimensions: 8.2 x 8.1 x 7.4 inches
- Item Weight: 3.60 Pounds
- Fitment Type: Direct Replacement
- Part Description: 2002 Buick LeSabre Throttle Body Assembly
Vehicle Fitment- 2002 Buick LeSabre | Custom, Limited | 6 Cyl 3.8 L GAS
FAQ for Throttle Body Repair
Q: What should be noticed when installing the accelerator controls cable bracket?
A:
You should not route flexible components (hoses, wires, conduits, etc.) within 50 mm (2 in) of moving parts unless flexible components can be securely fastened. This is necessary to prevent possible interference and damage to the component.
By Bob
GM Specialist
02/11/2022Q: What should be noticed when you install the accelerator control cable to the throttle body lever?
A:
You will need to assure the cable is under the hook in the throttle body lever.
By Bob
GM Specialist
02/11/2022Q: What should be noticed when you install the accelerator control cable through the slot in the accelerator pedal lever?
A:
The cable end fitting will snap into position and fit flush against the accelerator control pedal lever.
By Bob
GM Specialist
02/11/2022Q: What's the recommended torque for the two bracket bolts?
A:
The recommended torque is 16 N.m (12 lb-ft).
By Bob
GM Specialist
02/11/2022Q: What's the recommended torque for the IAC valve attaching screws?
A:
The recommended torque is 3 N.m (27 lb in).
By Bob
GM Specialist
01/11/2022Q: What should be noticed when installing the idle air control (IAC) valve?
A:
The IAC valve may be damaged if installed with the cone (pintle) extended more than 28 mm (1-1/8 in). You can measure the distance that the valve is extended before installing a new valve. The distance from the idle air control valve motor housing to the end of the idle air control valve pintle should be less than 28 mm (1-1/8 in). Manually compress the pintle until the extension is less than 28 mm (1-1/8 in).
By Bob
GM Specialist
01/11/2022See more FAQs (1)