Other Names: Brake Hose, Flex Hose, Front Flex Hose
Item Dimensions: 19.1 x 4.2 x 1.2 inches
Item Weight: 0.70 Pounds
Fitment Type: Direct Replacement
Replaces: 22163448, 17999966, 22163886
Part Description: 2002 Buick LeSabre HOSE ASM, FRT BRK
More Info
Vehicle Fitment
2002 Buick LeSabre | Custom, Limited | 6 Cyl 3.8 L GAS
FAQ for Brake Hose Repair
Q: Can I use used copper brake hose gaskets?
A:
No, you cannot. You must use new copper brake hose gaskets.
By Bob
GM Specialist
01/11/2022
Q: What's the recommended torque for the brake hose caliper bolt?
A:
The recommended torque is 44 Nm (32 ft. lbs.).
By Bob
GM Specialist
01/11/2022
Q: Can I assemble the used copper brake hose gaskets for the brake hose?
A:
No, you cannot. You must install new copper brake hose gaskets.
By Bob
GM Specialist
01/11/2022
Q: How to install the front brake hose?
A:
You may need to remove the rubber plug from the brake hose to the caliper bolt hole of the brake caliper, assemble the brake hose, the new copper brake hose gaskets, and the brake hose bolt to the brake hose.
By Bob
GM Specialist
01/11/2022
Q: Can I over-tighten the forcing screw?
A:
No, you cannot. You should not over-tighten the forcing screw or the flare may become oversized.
By Bob
GM Specialist
01/11/2022
Q: What should be noticed when replacing brake pipes?
A:
You will need to always use double-walled steel brake pipe when replacing brake pipes. The use of any other pipe is not recommended and may cause a brake system failure. Carefully route and ran replacement brake pipes. Always use the correct fasteners and the original location for replacement brake pipes.
By Bob
GM Specialist
01/11/2022
See more FAQs (1)
FAQ for Other Repair Info
Q: What's the proper way to install the intermediate park brake cable?
A:
The proper way is to connect the intermediate park brake cable to the equalizer, connect the right rear Parking Brake Cable to the intermediate park brake cable, insert the intermediate park brake cable into the cable retaining bracket and lock the intermediate park brake cable into place, connect the front of the intermediate park brake cable to the park brake cable connector, install the front park brake cable to the cable guides, lower the vehicle, cycle the park brake pedal 1 to 2 times to ensure that the park brake cable retainers are seated.
Q: What's the proper way to remove the power steering pressure hose?
A:
The proper way is to raise and support the vehicle, remove the steering gear heatshield, install a drain pan under the vehicle, remove the Power Steering Hose retainer from the engine frame at gear, remove the power steering pressure hose from the power steering gear, remove the power steering pressure hose from the power steering pump and remove the power steering pressure hose.
Q: What should be done before removing the vacuum booster attaching nuts from the brake pedal assembly?
A:
You will need to remove the vacuum Brake Booster pushrod from the brake pedal.