Part Description: 2001 GMC Yukon XL 1500 Handle Asm-Rear Door Outside T
More Info
Vehicle Fitment
2001 GMC Yukon XL 1500 | Denali, SLE, SLT | 8 Cyl 5.3 L FLEX, 8 Cyl 5.3 L GAS, 8 Cyl 6.0 L GAS
FAQ for Exterior Door Handle Repair
Q: How to remove the door outside handle?
A:
You shall remove the trim panel, the water deflector, the outside handle rod, the lock cylinder rod, the rubber cover, the door lock cylinder, and the handle.
By Bob
GM Specialist
01/11/2022
Q: What is the removal procedure for the door outside handle?
A:
The procedure is to install the handle, the door lock cylinder to the outside handle housing, the handle rod to the handle assembly clip, the rubber cover, the water deflector, and the trim panel.
By Bob
GM Specialist
01/11/2022
Q: How to remove the lock rod and outside handle-rear door?
A:
The proper way is to remove the trim panel, disconnect the lock cylinder rod from the rod clip, remove the outside handle nuts and the outside handle, disconnect the electrical connector, and remove the actuator cable and the door lock cylinder.
By Bob
GM Specialist
01/11/2022
Q: How to install the lock rod and outside handle-rear door?
A:
The proper way is to install the door lock cylinder and the actuator cable, connect the electrical connector, install the handle assembly connect the lock cylinder rod, and install the water deflector and the trim panel.
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: What should be learned about while servicing the door hinge pin and bushing-rear door?
A:
The Door Hinge pins and bushings are not replaceable. If the hinge pins or bushings are damaged, you shall replace the door hinge as an assembly.
Q: How to remove the rear side door lock actuator?
A:
The proper way is to remove the door trim panel and the water deflector, disconnect the inside door lock rod, the manual door lock rod, and the cylinder lock rod, and remove the Door Lock Actuator and control rods as an assembly.
Q: What is the installation procedure for the door lock switch?
A:
The procedure is to install the power door lock and power window switch assembly, and the screws to the Door Lock Switch, connect the electrical connector to the door lock switch and install the power accessory switch plate.