2001 GMC Yukon XL 1500 | Denali, SLE, SLT | 8 Cyl 5.3 L FLEX, 8 Cyl 5.3 L GAS, 8 Cyl 6.0 L GAS
FAQ for Cv Joint Repair
Q: What kind of tools will be required while servicing the wheel drive shaft outer joint and seal?
A:
The tools required include J 8059 Snap Ring Pliers, J 35910 Seal Clamp Tool, J 36652-98 Split Plate Swage Clamp (K1 5 models), and J 36652 Split Plate Swage Clamp (K25 models).
By Bob
GM Specialist
01/11/2022
Q: What should be noticed before disassembling the wheel drive shaft inner joint and seal?
A:
Before removing the half shaft, the transmission sealing surface should be inspected for corrosion. If corrosion is evident, the surface should be cleaned with 320 grit cloth or equivalent.
By Bob
GM Specialist
01/11/2022
Q: What should be noticed while assembling the wheel drive shaft outer joint and seal?
A:
You shall be sure that the retaining ring side of the CV joint inner race faces the half-shaft bar before installation. The retaining snap ring inside of the inner race engages in the half-shaft bar groove with a click when the CV joint is in the proper position.
By Bob
GM Specialist
01/11/2022
Q: What kind of tools will be required before servicing the wheel drive shaft inner joint and seal?
A:
The tools required include J 8059 Snap Ring Pliers, J 35910 Seal Clamp Tool, J 36652-98 Split Plate Swage Clamp (K1 5 models), and J 36652-1 Split Plate Swage Clamp (K25 models).
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: What should be noticed before disassembling the universal joint-nylon injected ring?
A:
The proper way is to never clamp propeller shaft tubing in a vise as clamping could dent or deform the tube causing an imbalance or unsafe condition, and always clamp on one of the yokes and support the shaft horizontally.
Q: What should be noticed while installing the wheel drive shaft boot cover?
A:
Tighten the seal cover clamp as tight as possible without deforming the retaining clip. Clamps that are not tight enough allow the cover to slide upon the joint. This causes shortened service life.
Q: What is the removal procedure for the center bearing?
A:
The procedure is to remove the propeller shaft and the center bearing.