< Back ×
My Vehicle Change Vehicle
2001 GMC Yukon XL 1500
< Back to View All
Alignment Kits
- Department
- Prices
OEM (Genuine) 2001 GMC Yukon XL 1500 Cam Kit, Front Upper Control Arm Adjust
PartNumber: 12472859
Product Specifications- Notes: 2WD, W/Coil Springs, 1500 Series; 2WD, W/Torsion Bar, 1500 Series; 4WD, 1500 Series
- Location: Driver Side; Passenger Side
- Other Names: Adjust Cam
- Item Dimensions: 6.1 x 5.8 x 3.3 inches
- Item Weight: 2.60 Pounds
- Part Description: 2001 GMC Yukon XL 1500 Cam Kit, Front Upper Control Arm Adjust
Vehicle Fitment- 2001 GMC Yukon XL 1500 | Denali, SL, SLE, SLT | 8 Cyl 5.3 L FLEX, 8 Cyl 5.3 L GAS, 8 Cyl 6.0 L GAS
FAQ for Camber and Alignment Kit Repair
Q: What is the proper way to adjust the front caster and camber?
A:
The proper way is to determine the caster angle and the camber angle, remove the pinned adjusting cam insert, loosen the upper control arm cam adjustment bolts, and adjust the caster and the camber angle by turning the cam bolts until the specifications have been met.
By Bob
GM Specialist
01/11/2022Q: What should be noticed while measuring the front and rear alignment angles?
A:
When performing adjustments to vehicles requiring a 4-wheel alignment, you shall set the rear wheel alignment angles first to obtain proper front alignment angles.
By Bob
GM Specialist
01/11/2022Q: How to properly adjust the front wheel Toe?
A:
The proper way is to loosen the jam nut on the tie rod, rotate the inner tie rod to the required toe specification setting, tighten the jam nut on the tie rod, check the toe setting after tightening, and re-adjust the toe setting if necessary.
By Bob
GM Specialist
01/11/2022Q: How to properly measure the trim height?
A:
The proper way is to set the tire pressures to the pressure shown on the certification label, check the fuel level, make sure the rear compartment is empty except for the spare tire, make sure the vehicle is on a level surface, and close the doors and the hood. All dimensions are measured vertically to the ground.
By Bob
GM Specialist
01/11/2022Q: What should be noticed while adjusting the front caster and camber?
A:
Before adjusting the caster and camber angles, you shall jounce the front bumper three times to allow the vehicle to return to its normal height.
By Bob
GM Specialist
01/11/2022Q: What should be noticed before measuring the Z height?
A:
Kmodels only the Z height must be adjusted before the alignment.
By Bob
GM Specialist
01/11/2022Q: How to measure the front and rear alignment angles?
A:
The proper way is to install the alignment equipment, jounce the front and the rear bumpers 3 times before checking the wheel alignment, measure the alignment angles, record the readings, and adjust alignment angles to vehicle specification if necessary.
By Bob
GM Specialist
01/11/2022See more FAQs (2)