Part Description: 2001 GMC Savana 1500 Transmission Mount
Vehicle Fitment
2001 GMC Savana 1500 | Base, SLE, SLT | 8 Cyl 5.7 L GAS
FAQ for Transmission Mount Repair
Q: What is the removal procedure for the transmission mount?
A:
You need to support the transmission assembly, remove the bolts and washers from the rear engine mount, raise the transmission assembly just enough to permit removal of the rear engine mount and remove the rear engine mount.
By Bob
GM Specialist
01/11/2022
Q: How to install the transmission mount?
A:
You need to install the rear engine mount to the transmission and the rear engine mount bolts, lower the rear of the engine, install the nut and washer to the rear engine mount, remove the transmission stand, and lower the vehicle.
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: What is the removal procedure for the vehicle speed sensor (VSS)-4L80-E?
A:
You need to disconnect the speed sensor connectors, remove the vehicle speed sensor bolts, the Vehicle Speed Sensors, and the bracket assemblies, and inspect the vehicle speed sensor assemblies.
Q: What is the removal procedure for the automatic transmission fluid/filter?
A:
You need to raise the vehicle, place a drain pan under the transmission oil pan, remove the oil pan drain plug, the oil pan bolts, the oil pan, the gasket, the fluid filter, and the seal, and retain the seal for reuse.
Q: Why can't I reuse the transmission fluid I use for flushing?
A:
The very fine metal and clutch material debris from the transmission failure in the ATF cause failures with the hall effect speed sensors that are used to measure the flow rate. To avoid costly repairs, expensive filters, regular maintenance, and problems caused by a partially restricted filter, the filter was not included.