< Back ×
My Vehicle Change Vehicle
2001 GMC Savana 1500
< Back to View All
Control Arms & Suspension Rods
- Department
- Prices
OEM (Genuine) 2001 GMC Savana 1500 Steering Knuckle Assembly
PartNumber: 18060574
Product Specifications- Notes: 1/2 Ton
- Location: Passenger Side
- Other Names: Knuckle
- Item Dimensions: 15.1 x 11.8 x 10.5 inches
- Item Weight: 17.10 Pounds
- Fitment Type: Direct Replacement
- Replaces: 15981299
- Part Description: 2001 GMC Savana 1500 Steering Knuckle Assembly
Vehicle Fitment- 2001 GMC Savana 1500 | Base, SLE, SLT | 6 Cyl 4.3 L GAS, 8 Cyl 5.0 L GAS, 8 Cyl 5.7 L GAS
OEM (Genuine) 2001 GMC Savana 1500 Steering Knuckle Assembly
PartNumber: 18060573
Product Specifications- Notes: 1/2 Ton
- Location: Driver Side
- Other Names: Knuckle
- Item Dimensions: 14.8 x 11.8 x 10.3 inches
- Item Weight: 19.50 Pounds
- Fitment Type: Direct Replacement
- Replaces: 15981298
- Part Description: 2001 GMC Savana 1500 Steering Knuckle Assembly
Vehicle Fitment- 2001 GMC Savana 1500 | Base, SLE, SLT | 6 Cyl 4.3 L GAS, 8 Cyl 5.0 L GAS, 8 Cyl 5.7 L GAS
FAQ for Steering Knuckle Repair
Q: What is the removal procedure for the steering knuckle?
A:
You need to raise the front of the vehicle, place safety stands under the control arms, remove the tire and wheel assembly, disconnect the tie rod, remove the front brake caliper, the hub/rotor, the steering knuckle seal, and the three bolts that attach the splash shield to the knuckle, separate the upper and the lower ball joint studs, and remove the wheel speed sensor and the knuckle.
By Bob
GM Specialist
02/11/2022Q: What is the recommended torque for the bolts to the splash shield?
A:
The recommended torque is 24 Nm (18 ft. lbs.).
By Bob
GM Specialist
02/11/2022Q: What is the procedure to remove the knuckle?
A:
The procedure is to clean the steering knuckle and inspect the steering knuckle tapered hole. If this tapered hole is out-of-round, deformed, or damaged, you should replace the knuckle.
By Bob
GM Specialist
02/11/2022