Part Description: 2001 GMC Savana 1500 Ignition Coil
More Info
Vehicle Fitment
2001 GMC Savana 1500 | All Trims | All Engines
FAQ for Ignition Coil Repair
Q: What is the removal procedure for the ignition coil(s)?
A:
You need to remove the engine cover, disconnect the electrical connectors, remove the ignition coil wire to the distributor, the studs holding the bracket and the ignition coil to the intake manifold, the bracket and the ignition coil, drill and punch out the two rivets, and remove the ignition coil from the bracket.
By Bob
GM Specialist
01/11/2022
Q: What is the recommended torque for the ignition coil to the bracket with the two screws.?
A:
The recommended torque is 11 Nm (97 lb in).
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: How to install the ignition control module?
A:
You need to install the Ignition Control Module and the heat sink on the bracket with the screws, reconnect the electrical connectors and install the engine cover.
Q: What is the removal procedure for the knock sensor?
A:
You need to turn off the ignition, drain the cooling system, raise the vehicle, remove the Knock Sensor harness connector and remove the knock sensor.
Q: How to inspect the internal components of the distributor ignition system?
A:
You need to inspect the Distributor cap the distributor rotor and the distributor base.