FAQ for Hvac Heater Blend Door Actuator Repair
Q: How to install the recirculation actuator?
A:
You need to install the recirculation actuator linkage and the recirculation actuator, connect the recirculation vacuum harness to the recirculation actuator and install the passenger-side knee bolster and the engine cover.
By BobGM Specialist
01/11/2022 Q: How to install the air temperature actuator?
A:
You need to install the air temperature actuator and the air temperature actuator retaining screws, connect the electrical connector to the air temperature actuator, and install the passenger-side knee bolster.
By BobGM Specialist
01/11/2022 Q: What is the removal procedure for the temperature actuator in the auxiliary?
A:
You need to remove the left rear quarter trim panel, disconnect the electrical connector from the actuator, and remove the retaining screws and the air temperature actuator.
By BobGM Specialist
01/11/2022 Q: How to install the mode actuator in the auxiliary?
A:
You need to install the mode actuator to the vehicle, the retaining screws to the actuator, and the heater case.
By BobGM Specialist
01/11/2022 Q: What is the recommended torque for the retaining screws to the actuator?
A:
The recommended torque is 1.9 Nm (17 lb in).
By BobGM Specialist
01/11/2022 Q: How to install the defroster actuator?
A:
You need to install the defrost actuator to the heater module, connect the vacuum hose to the defrost actuator, and install the instrument panel to the vehicle.
By BobGM Specialist
01/11/2022 Q: How to install the mode actuator (Upper)?
A:
You need to install the linkage to the lower mode actuator and the lower mode actuator to the heater case, connect the vacuum hose to the lower mode actuator and install the instrument panel and the engine cover.
By BobGM Specialist
01/11/2022 Q: How to install the temperature actuator in the auxiliary?
A:
You need to install the air temperature actuator and the retaining screws, connect the electrical connector to the actuator and install the left rear quarter trim panel.
By BobGM Specialist
01/11/2022 Q: What is the removal procedure for the recirculation actuator?
A:
You need to remove the engine cover and the passenger side knee bolster, disconnect the recirculation vacuum harness, and remove the recirculation actuator and the recirculation actuator linkage.
By BobGM Specialist
01/11/2022 Q: How to install the mode actuator?
A:
You need to install the linkage to the upper mode actuator, the upper mode actuator to the heater case, connect the vacuum hose to the upper mode actuator, and install the instrument panel.
By BobGM Specialist
01/11/2022 See more FAQs (10)