Part Description: 2001 GMC Savana 1500 Rear Main Seal
More Info
Vehicle Fitment
2001 GMC Savana 1500 | Base, SLE, SLT | 6 Cyl 4.3 L GAS, 8 Cyl 5.0 L GAS, 8 Cyl 5.7 L GAS
$34.50MSRP: $57.12
You Save: $22.62 (40%)
FAQ for Crankshaft Seal Repair
Q: How to install the crankshaft seal retainer?
A:
You need to install the oil seal housing, the flywheel, and the transmission assembly.
By Bob
GM Specialist
29/10/2022
Q: What is the removal procedure for the front crankshaft seal?
A:
You need to remove the crankshaft balancer, remove the crankshaft front oil seal, and inspect the engine front cover seal bore and the crankshaft balancer sealing surface.
By Bob
GM Specialist
29/10/2022
Q: How to install the front crankshaft seal?
A:
You need to look to ensure that the pre-applied grease on the crankshaft front oil seal is intact, install the crankshaft front oil seal, inspect to ensure the crankshaft front seal is flush and square to the engine front cover, and install the crankshaft balancer.
By Bob
GM Specialist
29/10/2022
Q: What is the removal procedure for the crankshaft seal retainer?
A:
You need to remove the transmission assembly and the flywheel, loosen and lower the oil pan, and remove the crankshaft rear oil seal housing.
By Bob
GM Specialist
29/10/2022
FAQ for Other Repair Info
Q: How to install the heated oxygen sensor (HO2S) bank2 sensor 1?
A:
You need to coat the threads of the Oxygen Sensor with anti-seize compound GM P/N 5613695, install the HO2S using a J 39194-B, connect the HO2S harness connector, and lower the vehicle.
Q: What is the removal procedure for the spark plug wire?
A:
You need to remove the engine cover, disconnect the Spark Plug Wire at each spark plug on the left side and the right of the engine, disconnect the spark plug wire from the distributor, and remove the spark plug wires and the coil wire.
Q: How to install the valve latch?
A:
You need to install the Valve Lifters, the valve push rods, and the intake manifold.