Part Description: 2001 GMC Savana 1500 Blower Motor Resistor
Vehicle Fitment
2001 GMC Savana 1500 | Base, SLE, SLT | 6 Cyl 4.3 L GAS, 8 Cyl 5.0 L GAS, 8 Cyl 5.3 L GAS, 8 Cyl 5.7 L GAS
FAQ for Blower Motor Resistor Repair
Q: What is the removal procedure for the blower motor resistor assembly?
A:
You need to disconnect the electrical connectors from the blower motor resistor assembly and the blower motor and remove the retaining screws and the blower motor resistor assembly from the blower motor case.
By Bob
GM Specialist
01/11/2022
Q: What is the removal procedure for the auxiliary blower motor resistor?
A:
You need to remove the left rear quarter trim panels, disconnect the electrical connector from the blower motor resistor, and remove the retaining screws and the blower motor resistor.
By Bob
GM Specialist
01/11/2022
Q: How to install the blower motor resistor assembly in the auxiliary?
A:
You need to install the blower motor resistor into the blower case and the retaining screws to the blower case, connect the electrical connector to the blower motor resistor and install the left rear quarter trim panels.
By Bob
GM Specialist
01/11/2022
Q: How to install the blower motor resistor in the auxiliary?
A:
You need to install the blower motor resistor to the blower case and the retaining screws, connect the electrical connector to the blower motor resistor, and install the left rear quarter trim panels.
By Bob
GM Specialist
01/11/2022
Q: What is the recommended torque for the retaining screws to the blower motor case?
A:
The recommended torque is 2 Nm (18 lb in).
By Bob
GM Specialist
01/11/2022
Q: What is the removal procedure for the blower motor resistor assembly in the auxiliary?
A:
You need to remove the left rear quarter trim panels, disconnect the electrical connector from the blower motor resistor, remove the retaining screws, and remove the blower motor resistor from the blower case.
By Bob
GM Specialist
01/11/2022
See more FAQs (1)
FAQ for Other Repair Info
Q: How to install the heater core in the auxiliary?
A:
You need to install the Heater Core to the case, the screws to the bottom of the auxiliary heater case, the auxiliary heater case, and the left rear quarter trim panel.
Q: What is the removal procedure for the heater pipe in the auxiliary?
A:
You need to drain the engine coolant and remove the exhaust system, the heat shields, the Heater Hose connections, the heater hose connections, the retainers, and the intermediate heater pipe.
Q: What is the removal procedure for the blower motor relay in the auxiliary?
A:
You need to remove the body side rear trim panel, pull upward to remove the Blower Motor relay from the connector, and remove the blower motor relay.