2001 Chevrolet Venture Sliding Door Roller

You need to open the sliding door to gain access to the center roller bracket pin, support the rear of the sliding door, remove the pin from the center roller bracket, position the center roller bracket to the front radius of the sliding door center track, then release cable tension, remove the cable from the rear roller bracket, lift the center roller bracket upwards and remove the bracket from the center track, then detach the cable ends (power sliding door only).

You need to install the sliding door lower roller bracket to the lower track, install the sliding door catch with reinforcement channel bolt at the sliding door lower track, align the sliding door lower roller bracket to the grease pencil marks on the sliding door, install the sliding door lower roller bracket bolts, remove the support from the sliding door, then install the front edge of the sliding door inner trim panel to the sliding door.

You need to install the sliding door upper roller bracket to the front edge of the upper track, align the sliding door upper roller bracket to the grease pencil marks, install the sliding door upper roller bracket bolts, then remove the support from the sliding door, install the headliner trim finish molding, and install the sliding door garnish molding.

The recommended torque is 25 N.m (18 LB-FT).

You should ensure that the power sliding door cable barrels are properly installed into the sliding door center roller bracket cable retaining items located on the roller bracket.