Notes: Egr Valve, Vapor Canister And Sensors, Manifold; 3.4L; To Manifold; Federal;All Models; 3.4L; To Manifold; Federal
Other Names: Oxygen Sensor
Item Dimensions: 14.0 x 2.5 x 1.1 inches
Item Weight: 0.50 Pounds
Fitment Type: Direct Replacement
Replaces: 25315373
Part Description: 2001 Chevrolet Venture Sensor Asm, Heated Oxygen
More Info
Vehicle Fitment
2001 Chevrolet Venture | Base, LS, LT, Plus, Value, Warner Bros. | 6 Cyl 3.4 L GAS
$32.74MSRP: $105.35
You Save: $72.61 (69%)
FAQ for Oxygen Sensor Repair
Q: How to remove the heated oxygen sensor (HO2S) 2?
A:
You need to turn OFF the ignition, raise the vehicle, disconnect the sensor harness connector, then use the J 39194-B to carefully back out the heated oxygen sensor.
By Bob
GM Specialist
02/11/2022
Q: What should be done before serving the heated oxygen sensor (HO2S) 2?
A:
You should not remove this pigtail from either the heated oxygen sensor (HO2S) or the oxygen sensor (O2S). Removing the pigtail or the connector will affect sensor operation.
By Bob
GM Specialist
02/11/2022
Q: What is the recommended torque for the HO2S 1 (pre-catalytic converter)?
A:
The recommended torque is 41 N.m (30 lb-ft).
By Bob
GM Specialist
02/11/2022
Q: How to install the heated oxygen sensor (HO2S)?
A:
You need to coat the threads of the heated oxygen sensor/catalyst monitor with anti-seize compound GM P/N 5613695, or equivalent if necessary, install the heated oxygen sensor, connect the sensor electrical connector, and lower the vehicle.
By Bob
GM Specialist
02/11/2022
FAQ for Other Repair Info
Q: How to remove the oil pump?
A:
You need to remove the case side cover, remove the Oil Pump bolts, and remove the oil pump from the valve body, then clean and inspect the oil pump.
Q: What items should be inspected for about spark plug wire?
A:
You should inspect for correct routing of the Spark Plug Wires. inspect each wire for any signs of cracks or splits in the wire. then inspect each boot for the following conditions: tearing, piercing, arcing, carbon tracking, and corroded terminal.
Q: How to install the accelerator controls cable bracket?
A:
You need to position the accelerator cable bracket on the Throttle Body, install the nuts and bolts, then install the wire harness into the retainer, and finally install the air intake duct.