< Back ×
My Vehicle Change Vehicle
2001 Chevrolet Metro
< Back to View All
Wheel Hubs, Bearings & Seals
- Department
- Prices
OEM (Genuine) 2001 Chevrolet Metro Bolt-Serrated M12X1.25X38
PartNumber: 96062533
Product Specifications- Notes: Sedan W/O ABS
- Other Names: Hub Bolt, Wheel Stud
- Item Dimensions: 5.0 x 3.1 x 0.8 inches
- Item Weight: 1.00 Pounds
- Fitment Type: Direct Replacement
- Part Description: Bolt-Serrated M12X1.25X38
$13.06
FAQ for Wheel Hub Bolt Repair
Q: What is the removal procedure for the wheel stud (Hubless Design Without ABS)?
A:
You need to raise and support the vehicle, remove the rear tire and wheel assembly, the brake drum, and the dust cap, unstack the washer, remove the washer and the spindle nut, tap the brake drum to loosen the assembly, remove the drum from the spindle, and the wheel stud from the brake drum.
By Bob
GM Specialist
01/11/2022Q: What is the removal procedure for the wheel faster in the front?
A:
You need to raise and support the vehicle, remove the front tire and wheel assembly and the brake rotor, install 2 wheel nuts to 2 wheel studs, use a pry bar on the 2 nuts to prevent the hub from turning, and remove the wheel stud from the hub.
By Bob
GM Specialist
01/11/2022Q: How to install the wheel faster in the front?
A:
You need to insert the wheel stud into the wheel stud hole, install a washer and the wheel nut on the wheel stud, the 2 wheel nuts onto 2 wheel studs, and install a pry bar on the 2 nuts to prevent the hub from turning, pull the wheel stud, tighten the wheel nut to seat the wheel stud, remove the 3 wheel nuts and the washer, and install the brake rotor and the tire and wheel assembly.
By Bob
GM Specialist
01/11/2022Q: What is the recommended torque for the nut to the spindle?
A:
The recommended torque is 100 Nm (74 ft. lbs.).
By Bob
GM Specialist
01/11/2022Q: How to install the wheel stud (Hub Design With ABS)?
A:
You need to install 2 wheel nuts to 2 studs, use a pry bar between the 2 wheel nuts to prevent the hub from turning, a new stud to the hub, the washers onto the new stud, and the stud to the hub, remove the wheel nut and the washers, install the brake drum and the rear tire and wheel assembly, and lower the vehicle.
By Bob
GM Specialist
01/11/2022Q: What is the removal procedure for the wheel stud (Hub Design With ABS)?
A:
You need to raise and support the vehicle, remove the rear tire and wheel assembly, the 2 recessed screws, and the brake drum, install 2 wheel nuts to 2 studs, use a pry bar between the 2 wheel nuts, and remove the wheel stud.
By Bob
GM Specialist
01/11/2022See more FAQs (1)