2001 Chevrolet Metro Control Arm Bushing

You need to remove the parking brake lever trim bezel, loosen the adjuster nut on the parking brake lever assembly, remove the Parking Brake Cable from the parking brake lever assembly equalizer plate, raise and support the vehicle, remove the rear tire and wheel assemblies, the two guide brackets from the cable, the cable grommet, the drums, and the parking brake cable, and squeeze the parking brake cable retainer, and remove the parking brake cable from the backing plate.

You need to raise and support the vehicle, remove the tire and wheel assembly, the brake caliper, the caliper carrier, the rotor, the wheel speed sensor electrical connector, the one bolt, and the wheel speed sensor, and remove and remove the drive axle nut and washer, remove the hub, the cotter pin, and the castle nut, the tie rod end, the ball stud nut and bolt, the two strut-to-knuckle bolts and nuts and the Steering Knuckle.

You need to disassemble the boots, the pistons, the cup seals, the spring, and the bleeder valve, clean the Wheel Cylinder body in clean brake fluid, dry the wheel cylinder body, and inspect the wheel cylinder body, the piston, the cup seals and the spring.