Q: What is the recommended torque for the backup lamp switch?
A:
The recommended torque is 23 Nm (17 ft. lbs.).
By Bob
GM Specialist
01/11/2022
Q: What is the removal procedure for the backup lamp switch?
A:
You need to disconnect the connector from the backup lamp switch, remove the backup lamp switch wire from the retaining clamp and the backup lamp switch from the left case, inspect the backup lamp switch O-ring, and replace the O-ring.
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: What is the removal procedure for the turn signal flasher?
A:
You need to disable the SIR system, remove the 2 plastic retainers and the left hinge pillar trim, the bolt, and lower the junction block to access the turn signal lamp flasher, and the turn signal lamp flasher.
Q: What is the recommended torque for the stop lamp switch locknut?