Contact Us Live Chat or 1-888-220-8330
Search Bar
Search by Part Number or Keywords
  • My Garage
  • My Account
  • Cart
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting
Help Center
< Back ×
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting
Login/Register My Account Track Order Help Center Contact Us
Replacement and OEM Parts for 2001 Chevrolet Metro A/C Clutch

2001 Chevrolet Metro A/C Clutch

My Vehicle Change Vehicle
2001 Chevrolet Metro
Change Vehicle
Vehicle Options
We need more information about your vehicle to make a correct determination of fitment
< Back to View All
A/C & Heating
  • Department
  • Prices

5 Products found

2 Q&A for A/C Clutch Repair
Show Item:
  • 30
  • 60
  • 90
Sort by:
Recommended
Filter
Sort
View by

FAQ for A/C Clutch Repair

Q: What is the recommended torque for the pressure plate nut?
A:
The recommended torque is 15-20 Nm (10.8-15.2 lb-ft).
By Bob
GM Specialist
01/11/2022
Q: What is the removal procedure for the compressor clutch coil?
A:
You need to remove the compressor, the pressure plate nut and the washer from the drive shaft, the pressure plate from the drive shaft, the clutch pulley snap ring and the shim, the clutch pulley from the compressor, the 1 screw and the clutch coil wire retainer, the clutch coil snap ring using the snap ring pliers and the clutch coil from the compressor, inspect the pressure plate and the clutch pulley, and measure the clutch coil resistance.
By Bob
GM Specialist
01/11/2022

FAQ for Other Repair Info

Q: How to install the heater core?
A:
You need to install the Heater Core to the heater case and the heater case.
Q: How to install the blower motor resistor?
A:
You need to install the resistor to the blower case and connect the electrical connector of the Blower Motor Resistor electrical connector, and the PCM.
Q: What is the removal procedure for the condenser?
A:
You need to disable the Supplemental Inflatable Restraint (SIR) system, discharge and recover the refrigerant, disconnect the negative battery cable, remove the front bumper, disconnect the hood latch cable, slide the hood latch cable out from the hood latch assembly, disconnect the electrical connector from the SIR forward discriminating sensor, disconnect the condenser fan electrical connector and the 2 horn electrical connections, remove 1 bolt and the horn, connect the Receiver-dryer outlet-to-evaporator inlet pipe fitting, remove 1 nut and the discharge hose, the 6 screws and the radiator center brace, the 2 condenser mounting bolts and the condenser, cap the refrigerant system openings, remove the 2 bolts and the 2 screws from the condenser fan, and the condenser fan from the condenser.