You can turn the ignition off, and disconnect the spark plug wires, 2 screws, and the coil.
By Bob
GM Specialist
01/11/2022
Q: What is the recommended torque for the screw?
A:
The recommended torque is 4.5 N.m (40 lb in).
By Bob
GM Specialist
01/11/2022
Q: How to install the ignition coil?
A:
You can attach the coil assembly, install two attaching screws, and connect the spark plug wires.
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: How to install the ignition control module?
A:
You can attach the coils, and the Ignition Control Module, install the screws and connect the spark plug wires, and the 14-way connector to the module.
Q: How to install the knock sensor?
A:
You can install the Knock Sensor, the knock sensor heat shield, the knock sensor electrical connector to the knock sensor, the splash shield, and fill the cooling system.
Q: What should I pay attention to about the engine control module?
A:
You may not program a control module unless you are directed by a service procedure or you are directed by a General Motors Corporation service bulletin. Programming a control module at any other time will not permanently correct a customer's concern.