2000 GMC Savana 1500 Thermostat Housing

You can install the new gaskets, the thermostat housing crossover, and the studs and bolts retaining the thermostat housing crossover to the engine, connect the upper radiator hose to the thermostat housing crossover, the by-pass hose to the thermostat housing crossover, the heater hose to the thermostat housing crossover, the electrical connector to the coolant temperature sensor, install the A/C compressor, the stud securing the fuel bleed valve at the thermostat housing, the nut securing the dipstick tubes at the thermostat housing, connect the battery negative cable to the auxiliary battery terminal, the battery negative cable to the battery terminal, refill the engine cooling system, bleed the air from the engine cooling system, install the cap on the surge tank, the air intake duct to the turbocharger, the air cleaner assembly in the vehicle.

You can disconnect the battery negative cable, the battery negative cable from the auxiliary battery terminal, drain the coolant from the radiator, remove the air cleaner assembly from the vehicle, the air intake duct from the turbocharger, the nut securing the dipstick tubes at the thermostat housing, the stud securing the fuel bleed valve at the thermostat housing, the A/C compressor, disconnect the coolant temperature sensor electrical connector, the heater hose at the thermostat housing crossover, the by-pass hose at the thermostat housing crossover, the upper radiator hose at the thermostat housing crossover, remove the studs and bolts securing the thermostat housing crossover to the engine, the thermostat housing crossover.

The recommended torque is 47 Nm (35 ft. lbs.).