2000 GMC Savana 1500 Idle Control Motor

You can disconnect the negative battery cable, remove the engine cover, disconnect the MAP Sensor harness connector, remove the MAP sensor by pulling straight up with a slight rocking motion, and discard the MAP sensor grommet.

You can disconnect the battery negative cable, remove the engine cover, the air cleaner intake duct, disconnect the fuel injector electrical connector, manifold Absolute Pressure (MAP) sensor, EVAP canister purge solenoid valve, idle Air Control (IAC) solenoid, throttle Position (TP) sensor, remove the vacuum brake booster hose, the PCV tube at the Intake Manifold, disconnect the spark plug wires from the left side of the distributor cap, remove the fuel pipes from the rear of the engine, AIR Bypass hose, the EVAP canister purge solenoid valve from the engine, the accelerator control cable and the cruise control cable, the accelerator control cable bracket from the throttle body and the intake manifold the upper intake manifold bolts from the engine and then remove the upper intake manifold.

You can attach the MAF sensor to the air cleaner cover by tightening the hose clamp, the air cleaner outlet duct to the MAF sensor by tightening the hose clamp, install the air cleaner cover by fastening the air cleaner cover retainer clips, connect the MAF sensor harness connector, the negative battery cable.