Notes: Knock Module must be removed from original PCM and installed in replacement PCM;Vehicle specific Flash programming req'd ON or OFF the vehicle.Accurate VIN & mileage are req'd. Additional vehicle specific on-car programming must be performed AFTER installation to prevent drivability & starting issues.
2000 GMC Savana 1500 | Base, SLE, SLT | 6 Cyl 4.3 L GAS, 8 Cyl 5.0 L GAS, 8 Cyl 5.7 L GAS
FAQ for Engine Control Module Repair
Q: What is the recommended torque for the access cover screws?
A:
The recommended torque is 4.8 N.m (42 lb in).
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: How do you install the ignition coil?
A:
You can install the Ignition Coil to the bracket with the two screws, the ignition coil, and the bracket to the intake manifold with studs, the ignition coil wire, the electrical connectors, the air cleaner, and the engine cover.
Q: How do you remove the knock sensor?
A:
You can disconnect the negative battery cable, and remove the Knock Sensor harness connector, and the knock sensor from the cylinder block.