2000 GMC Savana 1500 | Base, LS, LT, SLE, SLT | 6 Cyl 4.3 L GAS, 8 Cyl 5.0 L GAS, 8 Cyl 5.3 L FLEX, 8 Cyl 5.3 L GAS, 8 Cyl 5.7 L GAS
$9.55MSRP: $20.04
You Save: $10.49 (53%)
FAQ for Daytime Running Light Relay Repair
Q: How do you remove the daytime running lamp relay?
A:
You can remove the instrument panel driver knee bolster panel, the relay center, and the bracket, the DRL relay.
By Bob
GM Specialist
29/10/2022
Q: How do you install the daytime running lamp relay?
A:
You can connect the DRL relay and install the relay center, the bracket, and the instrument panel driver knee bolster panel.
By Bob
GM Specialist
29/10/2022
Q: What is the recommended torque for bolts that retain the relay center and the bracket to the inner and outer brackets of the instrument panel driver knee bolster?
A:
The recommended torque is 4 N.m (35 lb in).
By Bob
GM Specialist
29/10/2022
FAQ for Other Repair Info
Q: How to remove Starter Motor?
A:
You can disconnect the battery negative cable, remove the Starter motor brackets and shields, disconnect the wires from the starter solenoid, remove the bolts and the shims (if present) from the starter motor, and the starter motor from the engine.
Q: What is the recommended torque for the park/turn signal lamp retaining screws?
A:
The recommended torque is 1.5 N.m (13 lb in).
Q: How do you remove the steering wheel module?
A:
You can disable the SIR system. Turn the ignition switch to the ON position. Turn the steering wheel 90 degrees Remove a screwdriver into each access hole and push the leaf spring. Turn the steering wheel 180 degrees. Insert a screwdriver into the remaining access holes and push the leaf spring. Disconnect the SIR lead wire, the Connector Position Assurance (CPA) retainer, and the electrical connector. Remove the inflator module.