Part Description: 2000 GMC Savana 1500 Arming Sensor
More Info
Vehicle Fitment
2000 GMC Savana 1500 | Base, SLE | 6 Cyl 4.3 L GAS, 8 Cyl 5.0 L GAS, 8 Cyl 5.7 L GAS
FAQ for Air Bag Sensor Repair
Q: How do you remove the steering wheel module?
A:
You can disable the SIR system. Turn the ignition switch to the ON position. Turn the steering wheel 90 degrees Remove a screwdriver into each access hole and push the leaf spring. Turn the steering wheel 180 degrees. Insert a screwdriver into the remaining access holes and push the leaf spring. Disconnect the SIR lead wire, the Connector Position Assurance (CPA) retainer, and the electrical connector. Remove the inflator module.
By Bob
GM Specialist
01/11/2022
Q: How do you install the steering wheel module?
A:
You can install the electrical connector, the CPA retainer, the SIR lead wire, and the inflator module onto the steering wheel and press the module into the retaining tabs. Rotate the steering wheel back into the straight position. Enable the SIR system.
By Bob
GM Specialist
01/11/2022
Q: How do you remove the instrument panel module?
A:
You can disable the SIR system, remove the passenger knee bolster, and the connector Position Assurance (CPA). Disconnect the inflatable restraint IP module pigtail connector. Remove the inflatable restraint IP module mounting fasteners, and the inflatable restraint IP module.
By Bob
GM Specialist
01/11/2022
Q: How do you install the instrument panel module?
A:
You can install the inflatable restraint IP module and the inflatable restraint IP module mounting fasteners. Connect the inflatable restraint IP module pigtail connector. Install the Connector Position Assurance (CPA), and the passenger knee bolster. Enable the SIR system.
By Bob
GM Specialist
01/11/2022
Q: What is the recommended torque for the inflatable restraint IP module mounting fasteners?
A:
The recommended torque is 10 Nm (89 lb in).
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: How to remove Starter Motor?
A:
You can disconnect the battery negative cable, remove the Starter motor brackets and shields, disconnect the wires from the starter solenoid, remove the bolts and the shims (if present) from the starter motor, and the starter motor from the engine.
Q: What is the recommended torque for the park/turn signal lamp retaining screws?
A:
The recommended torque is 1.5 N.m (13 lb in).
Q: What is the recommended torque for the battery negative cable to the battery?