Part Description: 2000 GMC Safari Shield Asm-Front Wheelhouse Panel Splash
More Info
Vehicle Fitment
2000 GMC Safari | Base, SL, SLE, SLT, SLX | 6 Cyl 4.3 L GAS
FAQ for Fender Splash Shield Repair
Q: What's the removal procedure for the wheelhouse extension?
A:
The removal procedure is to use J 38778 to remove the retainers from the fender and the extension and the wheelhouse, then remove the extension from the wheelhouse.
By Bob
GM Specialist
01/11/2022
Q: What's the installation procedure for the wheelhouse splash shield?
A:
The installation procedure is to install the wheelhouse splash shield to the wheelhouse and push the retainers into the wheelhouse holes to retain the splash shield in the wheelhouse.
By Bob
GM Specialist
01/11/2022
Q: What's the removal procedure for the wheelhouse splash shield?
A:
The removal procedure is to use J 38778 to remove the retainers from the wheelhouse and the splash shield, then remove the wheelhouse splash shield from the wheelhouse.
By Bob
GM Specialist
01/11/2022
Q: What's the installation procedure for the wheelhouse extension?
A:
The installation procedure is to install the extension to the wheelhouse and install the extension push pins to the wheelhouse.
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: What's the removal procedure for the door switch?
A:
The removal procedure is to loosen the nut on the Door Jamb Switch, gently pull the switch away from the body, disconnect the door jamb switch from the electrical connector(s), tape the wiring to the body to prevent the wiring from entering the hole in the door pillar, then remove the door jamb switch from the vehicle.
Q: What's the installation procedure for the power door lock actuator?
A:
The installation procedure is to install the actuator to the door, install the actuator to door rivets, then connect the power Door Lock Actuator wiring harness and install the power door lock actuator to the remote lever rod, finally install the water deflector and the trim panel.
Q: What's the installation procedure for the secondary hood latch?
A:
The installation procedure is to install the secondary Hood Latch to the hood, position the tab into the slot, then install the hood latch bolt and tighten it to 27 N.m (20 lb-ft).