FAQ for Door Moldings Repair
Q: What's the removal procedure for the body side cladding?
A:
The removal procedure is to remove the cladding from the body.
By BobGM Specialist
28/10/2022 Q: What's the installation procedure for the body-side cladding?
A:
The installation procedure is to install the cladding to the body.
By BobGM Specialist
28/10/2022 Q: What's the installation procedure for the rear cladding?
A:
The installation procedure is to install the cladding to the rear quarter panel, then install the wheel opening screws and tighten the wheel opening screws to 2 N.m (18 lb in).
By BobGM Specialist
28/10/2022 Q: What's the removal procedure for the rocker panel cladding?
A:
The removal procedure is to remove the screws from the cladding, remove the retainers from the wheelhouse, remove the nut on the back of the cladding from the stud, then remove the cladding from the retaining rail, next remove the retaining rail screws, and remove the retaining rail from the body.
By BobGM Specialist
28/10/2022 Q: How to remove the front door blackout transfer?
A:
You will need to remove the door trim panel, remove the door window run channel from the door frame, then remove the emblem from the door, use a heat gun or other suitable tool to heat the transfer, then slowly peel the transfer from the door.
By BobGM Specialist
28/10/2022 Q: What should be done if the paint in the area is chipped or gouged?
A:
You will need to repaint the area, otherwise, the surface imperfection will be visible through the blackout transfer.
By BobGM Specialist
28/10/2022 Q: What's the removal procedure for the body-side blackout transfer?
A:
The removal procedure is to remove the interior trim, as needed, to ease window removal, then remove the swing-out and/or stationary window(s), and remove the body side swing-out window weather-strip, if equipped, lastly use a heat gun or other suitable tool to heat the transfer and slowly peel the transfer from the body.
By BobGM Specialist
28/10/2022 Q: What should be noticed when removing the body side blackout transfer?
A:
You will need to apply for all transfers in a clean environment where dust or fibers will not interfere with proper adhesion.
By BobGM Specialist
28/10/2022 Q: What's the removal procedure for the rear cladding?
A:
The removal procedure is to remove the wheel opening screws and then remove the cladding from the rear quarter panel.
By BobGM Specialist
28/10/2022 Q: What's the installation procedure for the rocker panel cladding?
A:
The installation procedure is to install the retaining rail to the body, install the retaining rail screws, install the cladding to the vehicle, install the nut on the back of the cladding to the stud, install the screws into the cladding, then install the retainers into the wheelhouse extension flange.
By BobGM Specialist
28/10/2022 See more FAQs (5)