2000 GMC Safari | Base, SL, SLE, SLT, SLX | 6 Cyl 4.3 L GAS
FAQ for Door Lock Cylinder Repair
Q: What should be done if door lock cylinders require replacement?
A:
You will need to apply a coating of GM P/N 12346241 or equivalent lubricant inside of the lock case and the cylinder keyway before assembling and installing the cylinder.
By Bob
GM Specialist
01/11/2022
Q: Can I install used plastic retainer clips?
A:
No, you cannot. You should install new plastic retainer clips whenever the lock rods are removed.
By Bob
GM Specialist
01/11/2022
Q: What's the recommended torque for the outside handle nuts?
A:
The recommended torque is 7 N.m (62 lb in).
By Bob
GM Specialist
01/11/2022
Q: What's the recommended torque for the license plate housing bolts?
A:
The recommended torque is 4 N.m (35 lb in).
By Bob
GM Specialist
01/11/2022
Q: What's the recommended torque for the nuts installed on the door handle?
A:
The recommended torque is 6 N.m (53 lb in).
By Bob
GM Specialist
01/11/2022
Q: How to remove the control rod from the outside handle?
A:
You should pry the clip anchor out of the hole, push the clip away from the lever, then pull the rod and the clip away from the lever.
By Bob
GM Specialist
01/11/2022
Q: What's the recommended torque for the license lamp bolts?
A:
The recommended torque is 4 N.m (35 lb in).
By Bob
GM Specialist
01/11/2022
See more FAQs (2)
FAQ for Other Repair Info
Q: What's the removal procedure for the door switch?
A:
The removal procedure is to loosen the nut on the Door Jamb Switch, gently pull the switch away from the body, disconnect the door jamb switch from the electrical connector(s), tape the wiring to the body to prevent the wiring from entering the hole in the door pillar, then remove the door jamb switch from the vehicle.
Q: What's the installation procedure for the power door lock actuator?
A:
The installation procedure is to install the actuator to the door, install the actuator to door rivets, then connect the power Door Lock Actuator wiring harness and install the power door lock actuator to the remote lever rod, finally install the water deflector and the trim panel.
Q: What's the removal procedure for the rear sliding door lock striker?
A:
The removal procedure is to remove the right-hand body side trim panel, the two bolts that retain the rear storage compartment if equipped, the bolts, the striker, the spacer, the washer, and the nut plate.