Part Description: 2000 GMC Safari Door Jamb Switch
More Info
Vehicle Fitment
2000 GMC Safari | Base, SL, SLE, SLT | 6 Cyl 4.3 L GAS
$13.92MSRP: $20.99
You Save: $7.07 (34%)
FAQ for Door Jamb Switch Repair
Q: What's the removal procedure for the door switch?
A:
The removal procedure is to loosen the nut on the door jamb switch, gently pull the switch away from the body, disconnect the door jamb switch from the electrical connector(s), tape the wiring to the body to prevent the wiring from entering the hole in the door pillar, then remove the door jamb switch from the vehicle.
By Bob
GM Specialist
01/11/2022
Q: What's the installation procedure for the door switch?
A:
The installation procedure is to install the door jamb switch, connect the electrical connector(s) to the door jamb switch, and tighten the nut on the door jamb switch to 3 N.m (27 lb in).
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: What's the installation procedure for the power door lock actuator?
A:
The installation procedure is to install the actuator to the door, install the actuator to door rivets, then connect the power Door Lock Actuator wiring harness and install the power door lock actuator to the remote lever rod, finally install the water deflector and the trim panel.
Q: What's the installation procedure for the rear sliding door lock striker?
A:
The installation procedure is to install the nut plate, the washer, the spacer, the striker, and the striker bolts, then tighten the striker bolts to 24 N.m (18 lb-ft), and install the right-hand body side trim panel.
Q: What's the recommended torque for the nuts that retain the roller track?